Changeset 21501

Timestamp:

01/27/17 11:51:54 (8 years ago)

Author:

jbondzio

Message:

CHG: relaxing geometry tolerances

File:

• issm/trunk-jpl/src/m/classes/mesh3dprisms.m (modified) (1 diff)

issm/trunk-jpl/src/m/classes/mesh3dprisms.m

@@ -109 +109 @@
                         md = checkfield(md,'fieldname','mesh.z','>=',md.geometry.base-10^-10,'message','''mesh.z'' lower than bedrock');
                         md = checkfield(md,'fieldname','mesh.z','<=',md.geometry.surface+10^-10,'message','''mesh.z'' higher than surface elevation');
-                        if any(max(abs(project2d(md,md.mesh.z,1)-project2d(md,md.geometry.base,1)))>1e-11),
+                        if any(max(abs(project2d(md,md.mesh.z,1)-project2d(md,md.geometry.base,1)))>1e-10),
                                 md = checkmessage(md,'md.mesh.z is not consistent with md.geometry.base, you changed the geometry after extrusion');
                         end
-                        if any(max(abs(project2d(md,md.mesh.z,md.mesh.numberoflayers)-project2d(md,md.geometry.surface,1)))>1e-11),
+                        if any(max(abs(project2d(md,md.mesh.z,md.mesh.numberoflayers)-project2d(md,md.geometry.surface,1)))>1e-10),
                                 md = checkmessage(md,'md.mesh.z is not consistent with md.geometry.surface, you changed the geometry after extrusion !!');
                         end
-                        if any(max(abs(project2d(md,md.mesh.z,md.mesh.numberoflayers)-project2d(md,md.mesh.z,1) - project2d(md,md.geometry.thickness,1)))>1e-11),
+                        if any(max(abs(project2d(md,md.mesh.z,md.mesh.numberoflayers)-project2d(md,md.mesh.z,1) - project2d(md,md.geometry.thickness,1)))>1e-10),
                                 md = checkmessage(md,'md.mesh.z is not consistent with md.geometry.thickness, you changed the geometry after extrusion !!');
                         end